GRIZZLY: I am showing that the Router Table has 18" of travel from left to
right. I hope this will be of some assistance.
unless they're wrong............................
From center point that means 9" travel left and 9" travel right (18) or does
it move 18 left 18 inches right. (36) I'd opt he didn't take out his 30"
pieces of wood and look at it!
So in my mind according to Grizzly if you draw the 30 inch table back the
left side would align 3 inches to the right of the bit! then you could only
travel 18" ????
I'll get back on them.........................
"Upscale" <[email protected]> wrote in message
news:[email protected]...
> "BillyBob" <[email protected]> wrote in message
>
> As I found out, they're talking about a built in sliding table on a router
> tavble, not a tablesaw.
Yes, I know. but what I was thinking was that, if anything, the router
table should have more travel than the tablesaw, as the tablesaw is
extremely conservatively designed with its solid cast iron sliding table
(much more weight than the aluminum slider on the router table).
Bob
"HMFIC- 1369" <PRC- [email protected]> wrote in message
news:hs4Qe.274$k32.185@trnddc08...
> GRIZZLY: I am showing that the Router Table has 18" of travel from left to
> right. I hope this will be of some assistance.
>
> unless they're wrong............................
That's ridiculous. Surely the guy is wrong. I get 24" travel out of my 27"
sliding table on the jet saw. 18" out of 30+"????? What's the use of even
having a sliding table? He's got to be wrong.
Bob
Yeah I know but it's an expensive bet to hedge........
You know I may drive all the way out there one weekend. It's over 200
miles... Hold on! I could buy the saw with the money I spend on gas to drive
there and back.
I sent Grizzly a more detailed description and if they wanted a sale to do
more then go to a table that's centered and move it right and say Oh 18
inches. You just can't get good help these days.....
"BillyBob" <[email protected]> wrote in message
news:[email protected]...
>
> "HMFIC- 1369" <PRC- [email protected]> wrote in message
> news:hs4Qe.274$k32.185@trnddc08...
> > GRIZZLY: I am showing that the Router Table has 18" of travel from left
to
> > right. I hope this will be of some assistance.
> >
> > unless they're wrong............................
>
> That's ridiculous. Surely the guy is wrong. I get 24" travel out of my
27"
> sliding table on the jet saw. 18" out of 30+"????? What's the use of
even
> having a sliding table? He's got to be wrong.
>
> Bob
>
>
"BillyBob" <[email protected]> wrote in message
> "HMFIC- 1369" <PRC- [email protected]> wrote in message
> > GRIZZLY: I am showing that the Router Table has 18" of travel from left
to
> > right. I hope this will be of some assistance.
>
> That's ridiculous. Surely the guy is wrong. I get 24" travel out of my
27"
> sliding table on the jet saw. 18" out of 30+"????? What's the use of
even
> having a sliding table? He's got to be wrong.
As I found out, they're talking about a built in sliding table on a router
tavble, not a tablesaw.