Porter Cable says they include one of these with their 7216 Ominjig, and it
is needed to cut 1/2" dovetails.
My new Omnijig did not have one, and when I complained to PC, they said it
was discontinued and not available.
I am trying to find one, and cannot; the only ones I find are the same size
on both cutter and bearing. Where can I buy such a thing?
You can buy bearings seperate from bits- I got a tin full of bearings.
-Dan V.
On Wed, 22 Dec 2004 05:35:47 GMT, "toller" <[email protected]> wrote:
>Porter Cable says they include one of these with their 7216 Ominjig, and it
>is needed to cut 1/2" dovetails.
>My new Omnijig did not have one, and when I complained to PC, they said it
>was discontinued and not available.
>
>I am trying to find one, and cannot; the only ones I find are the same size
>on both cutter and bearing. Where can I buy such a thing?
>
If you cannot find one I think a 9/16 bearing and bit will do if you replace
the bearing with a 1/2 x 5/8 or get a 1/4 inch shank and get a 14 x 5/8
bearing. I went the other way. I have a lathe and I made a sleeve that is
9/16 x 5/8 and pressed it over the bearing.
max
> Porter Cable says they include one of these with their 7216 Ominjig, and it
> is needed to cut 1/2" dovetails.
> My new Omnijig did not have one, and when I complained to PC, they said it
> was discontinued and not available.
>
> I am trying to find one, and cannot; the only ones I find are the same size
> on both cutter and bearing. Where can I buy such a thing?
>
>