I've recently picked up a Worksharp WS2000 sharpener and like it so
far, but I noticed on the sandpaper that the areas of the wheel that
don't have direct contact with the plastic wheel (due to it not being
a solid wheel) are not getting worn and the areas that have contact
are getting worn quickly. I thought maybe I'd pickup the glass wheel
to remedy this, but I notice that it says for the WS3000 only.
Does anyone know why it can't be used on the WS2000, or has someone
tried it anyways?
TIA,
Shawn
charlie b wrote:
> I think the difference between the two models is that the more expensive
> one has the four bevel angles quick set jig on it. Wheels, glass or
> the
> slotted plastic ones should work on both - though $20 for a glass wheel
> seems a bit much.
I have the WS3000 and Charlie is correct about the bevel angles. There
are four detents, 20, 25,30 & 35 degrees.
I didn't realize that the WS2000 came without the glass wheels and can't
see why they wouldn't work. After checking the online user manual for
the WS2000 I was surprised to see the manual specifically warns against
trying to use them.
--
Jack Novak
Buffalo, NY - USA
[email protected]
Nova wrote:
> I didn't realize that the WS2000 came without the glass wheels and can't
> see why they wouldn't work. After checking the online user manual for
> the WS2000 I was surprised to see the manual specifically warns against
> trying to use them.
Strange. The 2000 and 3000 seem to have the same motor and basic
set up - except for the four position tool holder? - and yet they
specify
that the tempered glass disks are NOT to be used on the 2000?
Sounds like a Marketing Department playing Product Differentation.
Actually it could be because the WS2000 spins at 1750 and the
WS3000 spins as 580 - and the extra weight of the glass disks
spinning three times faster on the WS2000 might tear up the
bearings.
But it should be noted that the base price of the units is only the
beginning of the ACTUAL cost. The PSA (peel and stick adhesive)
abbrasive disks can't be used again once removed. So if you use
four or five grits to go from regrind to mirror finish SHARP - you
either need THREE tempered glass disks (a grit on each face of each
gives you six surfaces for up to 6 different grits) - or - a LOT of
"sand paper" circles - OR - for the WS2000 - four or five slotted
plastic disks. So add another $60 to $80 to the price tag.