PM sells an adapter for this, but it's pretty expensive, $150 I think.
Also check www.cggschmidt.com. I think they carry one that is about $100.
Don't expect good results with small bits. I have a PM 26 also. The
spindle turns at 10k rpm at most, which won't give good results with bits
that require higher rpm.
Big John wrote:
> I purchased sometime back but have never used, a powermatic model 26
> shaper. It is in good shape and has a 5hp, 3ph motor. I can use my
> 3ph to single ph inverter and run it the same as I do my table saw.
>
> I would like to use my router bits. Is there a way to do this?
>
> Thanks, John