On Jun 7, 11:40=A0am, jcooper11 <[email protected]> wrote:
> Used to join sections of a bed, as a draw-bolt.
> Photos at this link...http://picasaweb.google.com/jcooper11/Hardware
In the photo, it looks like a forged part. Short of finding
a blacksmith, your best bet might be (1) find matching-diameter
rod stock or pipe, drilling/tapping/hacksawing, or (2) using a
regular nut and a really thick square chunk of steel as a
washer.
Alternative 2 will crush some of the wood fiber,but you
could combine the two, first lining the hole with a tube, then
piercing the tube and fitting a loose nut inside the tube.
Bed bolts are available, of course, but that's most useful for a
new design, won't necessarily fit your existing frame.
See, for instance,
<http://www.leevalley.com/hardware/page.aspx?
c=3D2&p=3D40445&cat=3D3,43715,43730&ap=3D1>
John wrote:
> On Sat, 07 Jun 2008 13:54:13 -0500, dpb <[email protected]> wrote:
>
>> jcooper11 wrote:
>>> Used to join sections of a bed, as a draw-bolt.
>>> Photos at this link...
>>> http://picasaweb.google.com/jcooper11/Hardware
>> That's a new one for me. Looks like could be fabricated fairly easily
>>from a piece of flat iron, though.
>
> Looks like the connectors for the joints in laminate countertops.
Ah...a one-tailed one, but would likely work, yes.
--
On Mon, 9 Jun 2008 15:58:08 -0700 (PDT), whit3rd <[email protected]>
wrote:
>http://picasaweb.google.com/jcooper11/Hardware
What's wrong with cutting a peice of the proper sized exhaust tubing
in half and to the proper length, and brazing a nut over a drilled
hole?
** Posted from http://www.teranews.com **
On Sat, 07 Jun 2008 13:54:13 -0500, dpb <[email protected]> wrote:
>jcooper11 wrote:
>> Used to join sections of a bed, as a draw-bolt.
>> Photos at this link...
>> http://picasaweb.google.com/jcooper11/Hardware
>
>That's a new one for me. Looks like could be fabricated fairly easily
>from a piece of flat iron, though.
Looks like the connectors for the joints in laminate countertops.
John
"dpb" <[email protected]> wrote in message news:[email protected]...
> John wrote:
>> On Sat, 07 Jun 2008 13:54:13 -0500, dpb <[email protected]> wrote:
>>
>>> jcooper11 wrote:
>>>> Used to join sections of a bed, as a draw-bolt.
>>>> Photos at this link...
>>>> http://picasaweb.google.com/jcooper11/Hardware
>>> That's a new one for me. Looks like could be fabricated fairly easily
>>> from a piece of flat iron, though.
>>
>> Looks like the connectors for the joints in laminate countertops.
>
> Ah...a one-tailed one, but would likely work, yes.
>
> --
I know this is a bit different but how about -
http://www.leevalley.com/hardware/page.aspx?c=1&p=40445&cat=3,40842,41269&ap=1