I am looking for a stile and rail bit set for cabinet doors on an Arts &
Crafts style project I'm planning. I am looking for a straight profile or
just the slightest bead. I have searched around and have not had much luck.
The closest to what I'm looking for is the 15 degree Shaker bevel profile
from Eagle America. Can anyone point me to where I could find something like
this?
Thanks
Steve H
Steve,
I would make the doors using Norm's method on the table saw if no ovolo is
required in the door. I have an Amana set that has an ovolo shape that works
well on Shaker style. It is Amana cat. no. 940.
"SteveH" <[email protected]> wrote in message
news:[email protected]...
> I am looking for a stile and rail bit set for cabinet doors on an Arts &
> Crafts style project I'm planning. I am looking for a straight profile or
> just the slightest bead. I have searched around and have not had much
luck.
> The closest to what I'm looking for is the 15 degree Shaker bevel profile
> from Eagle America. Can anyone point me to where I could find something
like
> this?
>
> Thanks
>
> Steve H
>
>
Steve,
I failed to mention that I'm talking about shaper cutters. :-)
"Lowell Holmes" <[email protected]> wrote in message
news:[email protected]...
> Steve,
> I would make the doors using Norm's method on the table saw if no ovolo is
> required in the door. I have an Amana set that has an ovolo shape that
works
> well on Shaker style. It is Amana cat. no. 940.
>
> "SteveH" <[email protected]> wrote in message
> news:[email protected]...
> > I am looking for a stile and rail bit set for cabinet doors on an Arts &
> > Crafts style project I'm planning. I am looking for a straight profile
or
> > just the slightest bead. I have searched around and have not had much
> luck.
> > The closest to what I'm looking for is the 15 degree Shaker bevel
profile
> > from Eagle America. Can anyone point me to where I could find something
> like
> > this?
> >
> > Thanks
> >
> > Steve H
> >
> >
>
>
If you are just wanting to cut for a straight profile, simply cut the groves
with your table saw and route the ends of the rails with a straight cut bit
to fit the grove.
When cutting the groves on the TS make one pass near the center and flip the
stile end for end to insure that the grove is centered non the piece.
Adjust the fence until the grove is the same width of the panel that you
will use. I make a lot of cabinet doors this way.
"SteveH" <[email protected]> wrote in message
news:[email protected]...
> I am looking for a stile and rail bit set for cabinet doors on an Arts &
> Crafts style project I'm planning. I am looking for a straight profile or
> just the slightest bead. I have searched around and have not had much
luck.
> The closest to what I'm looking for is the 15 degree Shaker bevel profile
> from Eagle America. Can anyone point me to where I could find something
like
> this?
>
> Thanks
>
> Steve H
>
>