I am trying to source (urgently) a part for an old Coronet Major wood
lathe. The part I'm after is one of the adjustable tool rest holders.
If someone would have one of these old lathes or parts thereof, please
email me and I shall send you pics of the exact part I'm after.
[email protected]
I'm in Sydney Australia.
Thanks all.
In article <[email protected]>, [email protected] wrote:
>I am trying to source (urgently) a part for an old Coronet Major wood
>lathe. The part I'm after is one of the adjustable tool rest holders.
>If someone would have one of these old lathes or parts thereof, please
>email me and I shall send you pics of the exact part I'm after.
You'll have better luck posting in rec.crafts.woodturning
Also try browsing http://www.owwm.com/
--
Regards,
Doug Miller (alphageek at milmac dot com)
It's time to throw all their damned tea in the harbor again.
On 6 Jan 2007 04:22:32 -0800, [email protected] wrote:
>I am trying to source (urgently) a part for an old Coronet Major wood
>lathe. The part I'm after is one of the adjustable tool rest holders.
>If someone would have one of these old lathes or parts thereof, please
>email me and I shall send you pics of the exact part I'm after.
>[email protected]
>I'm in Sydney Australia.
>Thanks all.
Adjustable tool rest holder?
Do you mean a banjo?
Might be a difference between countries... is it the part that clamps
down on the ways that the tool rest slides into?
If so, I don't think they change much from model to model. At least
in the case of both my Deltas, the clamping action is just from the
lever pulling a bolt with a washer on it tight against the underside.
If yours is even similar, I would imagine a replacement from any lathe
would work.