Howedy,
I've got a Delta TS-350 right now that I am attempting to install a
Vega UT50 on. The problem is that the power switch interferes with the
installatoin of the right hand front bracket. I'm looking at moving
the switch, but I was wondering about replacing it with a better switch
at the same time.
I've tried googling for "table saw power switch", but haven't found any
suppliers for replacement switches. Was wondering if anyone here had
any sources, and perhaps model suggestions. Also, any gotcha's that I
should be on the lookout for would be really appreciated too!!!
Thanks in advance,
Trace Wilson
"Trace Wilson" <[email protected]> wrote in message
>
> I've tried googling for "table saw power switch", but haven't found any
> suppliers for replacement switches.
Try magnetic switch.
I don't know if this is much help but my Ridgid TS 3650 switch is the
plastic key secured type and activates by pulling one end toward the
operator (hinges on the opposite end. I located it on the left side and
nudge it with my hip to turn it off. This is a 110vAC switch.
HTH
Check www.Ridgid.com for a diagram and part number
"Trace Wilson" <[email protected]> wrote in message
news:[email protected]...
> Howedy,
>
> I've got a Delta TS-350 right now that I am attempting to install a
> Vega UT50 on. The problem is that the power switch interferes with the
> installatoin of the right hand front bracket. I'm looking at moving
> the switch, but I was wondering about replacing it with a better switch
> at the same time.
>
> I've tried googling for "table saw power switch", but haven't found any
> suppliers for replacement switches. Was wondering if anyone here had
> any sources, and perhaps model suggestions. Also, any gotcha's that I
> should be on the lookout for would be really appreciated too!!!
>
> Thanks in advance,
>
> Trace Wilson
>