I assume you're speaking of a 2 part polyester or vinylester (epoxy)
resin like what we used in the fiberglass business. The resin is fairly
thick so it would self meter itself (drip) to a pretty thick coating.
Also, you'd stand a pretty good chance of the coating being a lot
thinner at the top than at the bottom where it would sag to, and most
likely have nipples on the bottom where it dripped off. If you're
looking for a clear coating on the wood and it's to be in the sun,
remember that Polyester resin doesn't stand up to UV, which is why boats
are covered with gel-coat or paint. For higher end epoxys, you can get
a special hardener designed to withstand the sun better which cures less
brown and more toward clear (light amber) so you can have the natural
wood look. I would suggest you hang the pieces from string and "paint"
them with the resin. Also, wood is porous enough to get good mechanical
adhesion without priming. Just make sure they're clean and dust free
before you start.
~Rob
[email protected] (Hugh Comstock) wrote in
news:[email protected]:
> Never used resin before. Would like to completely cover small wood
> pieces with a sticker on one side. Say a piece 2"x3". Can I dip it?
> won't the resin run off when i hang it to dry? does the wood have to
> be primed? any help appreciated. Thanks hugh/ohio
>
>
Gelcoat has a similar base to resin, but is colored so that you can have
the pretty finish coat. The other benefit is that it keeps direct sunlight
off the cured resin to keep it from breaking down. Normally it's sold
white and you can tint it to match the color you want.
"John Smith" <[email protected]> wrote inl
news:[email protected]:
> What is gelcoat? I thought it was just a thick coat of the resin, but
> you imply otherwise.
>
>