Aligning mitre slot to table saw blade

[email protected] wrote in news:1104720274.318739.248820
@f14g2000cwb.googlegroups.com:

> My mitre slot is just slightly out of adjustment on my Powermatic 66.
> Measuring accross the whole table with a dial indicator (with an
> aluminum bar up against the blade) I'm seeing about .030 (almost 1/32")
> deviation from parallel (narrower in the back). Using a dial gague is
> pretty wobbly and I'm sure the aluminum bar isn't absolutely flat, but
> I did repeated measurements with different bars and got the same
> result. However, just using Powermatic's suggested method of measuring
> with a combination square along the diameter of the blade (not the
> whole table), there's barely any measurable deviation, maybe .005".
>
> Is this worth loosening up the table and trying to true-up, knowing
> that I'll probably make it worse and have to futz with it to try to get
> right on?
>

Are you getting any indications in use that the blade/fence/slots are out
of alignment, or just with your somewhat non-standard measurement method?

Burning? Miters don't fit when they should? Kickback? Anything?

If the saw works, leave it alone. If it doesn't, then either google the
rec.norm archives or get a copy of a good tablesaw book. Authors Kelly
Mehler and Jim Tolpin come to mind.

Patriarch