Bb

"BrianInNY"

02/12/2006 2:37 PM

CLEANING WOOD FLOOR

I just purschased a home with a wood (not laminate) floor. What's the
best way to clean it? I'm more concerned with cleaning/sanatizing it,
as opposed to polishing it. Thanks in advance


This topic has 9 replies

Rd

"Robatoy"

in reply to "BrianInNY" on 02/12/2006 2:37 PM

02/12/2006 9:10 PM



On Dec 2, 8:24 pm, jo4hn <[email protected]> wrote:

>Ayup. Napalm cleaning service is good.

Tell a couple of Dutchmen that there's some money in the cracks...
they'll clean them right quick....

jj

jo4hn

in reply to "BrianInNY" on 02/12/2006 2:37 PM

02/12/2006 5:24 PM

Nova wrote:
> BrianInNY wrote:
>
>> I just purschased a home with a wood (not laminate) floor. What's the
>> best way to clean it? I'm more concerned with cleaning/sanatizing it,
>> as opposed to polishing it. Thanks in advance
>>
>
> A maid service works best for me.
>
> http://www.google.com/search?hl=en&q=Wood+floor+care&btnG=Google+Search
>
Ayup. Napalm cleaning service is good.

c

in reply to "BrianInNY" on 02/12/2006 2:37 PM

02/12/2006 11:41 PM

On 2 Dec 2006 14:37:04 -0800, "BrianInNY" <[email protected]> wrote:

>I just purschased a home with a wood (not laminate) floor. What's the
>best way to clean it? I'm more concerned with cleaning/sanatizing it,
>as opposed to polishing it. Thanks in advance
>

On hands and knees, wash the floor with a bucket of warm water (add a
few drops of dish soap to the water). Using a wrung out sponge scrub
it clean and let dry. Less water means more work to clean but less
likely to warp the floor boards. You need to wring out the sponge
frequently.

Using low odor solvent on a clean rag, wipe a circle on the floor to
see if there is wax. Use the solvent sparingly. After a few minutes
the wiped area (if there is wax ) will be look duller than the
surrounding floor. Now decide if you want to strip it all off and
rewax or just rewax the entire floor. If you strip the entire floor,
you'll need a lot of clean rags constantly turning and discarding
them. A single rag will only move wax from one place to another.

Sanitizing can be done with wiping the entire floor with alcohol
before rewaxing.

Pete

Pete

TN

"Tom Nie"

in reply to "BrianInNY" on 02/12/2006 2:37 PM

04/12/2006 8:30 AM

For me the ultimate ongoing cleaning is done with a Hoover Floor Mate. The
references on the other brand weren't good.

We've got red clay in our area and a Rotweiller. It cleans and leaves the
least amount of film - plus it only takes minutes to clean the floor while
standing :) We put nothing else on the floor.

Any moisture is sucked up from the seams/cracks. Ours is a poly high gloss
finish.

TomNie


"BrianInNY" <[email protected]> wrote in message
news:[email protected]...
>I just purschased a home with a wood (not laminate) floor. What's the
> best way to clean it? I'm more concerned with cleaning/sanatizing it,
> as opposed to polishing it. Thanks in advance
>

Nn

Nova

in reply to "BrianInNY" on 02/12/2006 2:37 PM

03/12/2006 6:18 PM

RonB wrote:
> We revitalized an Oak floor that had spent years under a carpet. The house
> was a rental we owned while our son was in college and we were trying to
> hold cost down. We used a retail-variety wood floor cleaner. As I recall
> it was made by Johnson's. It mixed with water and required a couple of
> vigorous hands and knees scrubbings to get it clean. I don't know what was
> in the solution but it smelled vaguely of ammonia and did a pretty good job
> because we were scrubbing some carpet pad remains as well as dirt.

<snip>

Most hardwood flooring places do not recommend using ammonia based
cleaning products (example):


"Straight ammonia or ammonia-based cleaning products should not be used
on hardwood floors because they will dull the finish and possibly cause
discoloration of the wood. Wet mopping with a liquid soap detergent or
using abrasive cleaners is also not recommended because either one has
the potential to strip the finish or cause it to deteriorate prematurely."

http://www.gardenandhearth.com/Home-Improvement/Cleaning-Hardwood-Floors.htm

--
Jack Novak
Buffalo, NY - USA
[email protected]

m

in reply to "BrianInNY" on 02/12/2006 2:37 PM

02/12/2006 11:22 PM

What condition are the floors now? How old are your floors and what kind of
wood and finish is on them wax, polyurethane or factory applied coatings?
The width also plays a role. A 4 inches wide maple versus 2¼" wide oak.
If it is a wax finish, mineral spirit and steel wool with elbow grease will
give good results. Then a new coat of wax.
At this time, until we know more about the type of wood floor you have I
prefer to wait to make further comments.



"BrianInNY" <[email protected]> wrote in message
news:[email protected]...
>I just purschased a home with a wood (not laminate) floor. What's the
> best way to clean it? I'm more concerned with cleaning/sanatizing it,
> as opposed to polishing it. Thanks in advance
>

m

in reply to "BrianInNY" on 02/12/2006 2:37 PM

02/12/2006 11:41 PM

I like your method. However, on older floor we often see a crevice between
boards. Over the years some of these floor boards have shrunk leaving a
cavity between boards. I always wonder if these separation gags could
harbour some unwanted stuff.
I have salvaged older discarded hardwood floors. I was surprised to see
what was in the groves. Many of the hardwood board ended up in the wood
stove.


<[email protected]> wrote in message news:[email protected]...
> On 2 Dec 2006 14:37:04 -0800, "BrianInNY" <[email protected]> wrote:
>
>>I just purschased a home with a wood (not laminate) floor. What's the
>>best way to clean it? I'm more concerned with cleaning/sanatizing it,
>>as opposed to polishing it. Thanks in advance
>>
>
> On hands and knees, wash the floor with a bucket of warm water (add a
> few drops of dish soap to the water). Using a wrung out sponge scrub
> it clean and let dry. Less water means more work to clean but less
> likely to warp the floor boards. You need to wring out the sponge
> frequently.
>
> Using low odor solvent on a clean rag, wipe a circle on the floor to
> see if there is wax. Use the solvent sparingly. After a few minutes
> the wiped area (if there is wax ) will be look duller than the
> surrounding floor. Now decide if you want to strip it all off and
> rewax or just rewax the entire floor. If you strip the entire floor,
> you'll need a lot of clean rags constantly turning and discarding
> them. A single rag will only move wax from one place to another.
>
> Sanitizing can be done with wiping the entire floor with alcohol
> before rewaxing.
>
> Pete
>
> Pete

Nn

Nova

in reply to "BrianInNY" on 02/12/2006 2:37 PM

02/12/2006 11:48 PM

BrianInNY wrote:
> I just purschased a home with a wood (not laminate) floor. What's the
> best way to clean it? I'm more concerned with cleaning/sanatizing it,
> as opposed to polishing it. Thanks in advance
>

A maid service works best for me.

http://www.google.com/search?hl=en&q=Wood+floor+care&btnG=Google+Search

--
Jack Novak
Buffalo, NY - USA
[email protected]

Rr

"RonB"

in reply to "BrianInNY" on 02/12/2006 2:37 PM

03/12/2006 10:56 AM

We revitalized an Oak floor that had spent years under a carpet. The house
was a rental we owned while our son was in college and we were trying to
hold cost down. We used a retail-variety wood floor cleaner. As I recall
it was made by Johnson's. It mixed with water and required a couple of
vigorous hands and knees scrubbings to get it clean. I don't know what was
in the solution but it smelled vaguely of ammonia and did a pretty good job
because we were scrubbing some carpet pad remains as well as dirt.

We followed up with a couple of coats of MinWax Paste that was buffed with a
power buffer and the result was very nice. I doubt if the paste is a good
long term solution but it lasted well during the 1-2 following years we
owned the house.

RonB


"BrianInNY" <[email protected]> wrote in message
news:[email protected]...
>I just purschased a home with a wood (not laminate) floor. What's the
> best way to clean it? I'm more concerned with cleaning/sanatizing it,
> as opposed to polishing it. Thanks in advance
>


You’ve reached the end of replies