On Aug 15, 1:48 pm, Pat Barber <[email protected]> wrote:
> It could be ordered with a scoring saw when new...
Pat-
I think it's likely I have the same saw you have, though I think I
paid a little more than you did. It came from a few miles north of you
in Valley center. Anyhow, I am trying to find out about the option of
retrofitting a scoring attachment to mine. were they offered in "with
attachment" and "without attachment" versions or is it a bolt on
accessory? if it is retrofittable, where the heck might I find one?
thanks
Bridger
On Aug 16, 12:52 pm, Pat Barber <[email protected]> wrote:
> It was an option on the 12/14 but I have only seen pictures
> of the one with the scoring saw. I assume that it would be
> a stone cold bitch to find "just" the scoring attachment.
>
> Those saws haven't been in production for well over 25
> years.(Mine was built in 04/66)
well, yeah.....
geeze, now I have a quest.
where to start. there should be a breakdown for it at ace tool repair,
if one knew the part number.
anybody know the part number?
hoping....
Bridger
It was an option on the 12/14 but I have only seen pictures
of the one with the scoring saw. I assume that it would be
a stone cold bitch to find "just" the scoring attachment.
Those saws haven't been in production for well over 25
years.(Mine was built in 04/66)
[email protected] wrote:
> On Aug 15, 1:48 pm, Pat Barber <[email protected]> wrote:
>
>>It could be ordered with a scoring saw when new...
>
>
>
> Pat-
> I think it's likely I have the same saw you have, though I think I
> paid a little more than you did. It came from a few miles north of you
> in Valley center. Anyhow, I am trying to find out about the option of
> retrofitting a scoring attachment to mine. were they offered in "with
> attachment" and "without attachment" versions or is it a bolt on
> accessory? if it is retrofittable, where the heck might I find one?
>
> thanks
> Bridger
>
It could be ordered with a scoring saw when new...
[email protected] wrote:
> anybody know if a scoring saw attachment will fit this saw?
>