"ScRaPLeR" <[email protected]> wrote in message
news:[email protected]...
> On Mon, 31 Oct 2005 18:39:50 -0800, David <[email protected]> wrote:
>
>>
> Opps, damn I was not thinking. the thickness matters not just as long
> as the bit height is at least the thickness and yes I am aware of the
> blue and red cuts. Thanks for taking time to respond. you are most
> kind.
>
This works great, and as you can see, it's not complicated.
http://us.oak-park.com/catalogue.html?list=boxj--
Of course, if I paid the dough for an Incra, I'd make it brew tea, and bake
biscuits to earn its keep.
On Mon, 31 Oct 2005 18:39:50 -0800, David <[email protected]> wrote:
>
Opps, damn I was not thinking. the thickness matters not just as long
as the bit height is at least the thickness and yes I am aware of the
blue and red cuts. Thanks for taking time to respond. you are most
kind.
ScRaPLeR
ScRaPLeR wrote:
>
>>
>> Can anyone tell me how to get one of the box joint templates for the
>> incra system to work with 1/2" stock when they only go up to 3/8" for
>> box joints? or tell me of an incra group, board, blog site, etc.
>>
>> Thanks in advance for any info
>I just did that. set the height of the bit a "skosh" higher than 1/2"
>and make your box joint cuts. I use the 1/4" bit. You DO know about
>the "blue" cuts and the "red" cuts, right?
>
>Dave
ScRaPLeR wrote:
>
> Can anyone tell me how to get one of the box joint templates for the
> incra system to work with 1/2" stock when they only go up to 3/8" for
> box joints? or tell me of an incra group, board, blog site, etc.
>
> Thanks in advance for any info
I just did that. set the height of the bit a "skosh" higher than 1/2"
and make your box joint cuts. I use the 1/4" bit. You DO know about
the "blue" cuts and the "red" cuts, right?
Dave
ScRaPLeR wrote:
> On Mon, 31 Oct 2005 18:39:50 -0800, David <[email protected]> wrote:
>
>
> Opps, damn I was not thinking. the thickness matters not just as long
> as the bit height is at least the thickness and yes I am aware of the
> blue and red cuts. Thanks for taking time to respond. you are most
> kind.
>
> ScRaPLeR
>
> ScRaPLeR wrote:
>
>>> Can anyone tell me how to get one of the box joint templates for the
>>>incra system to work with 1/2" stock when they only go up to 3/8" for
>>>box joints? or tell me of an incra group, board, blog site, etc.
>>>
>>>Thanks in advance for any info
>>
>>I just did that. set the height of the bit a "skosh" higher than 1/2"
>>and make your box joint cuts. I use the 1/4" bit. You DO know about
>>the "blue" cuts and the "red" cuts, right?
>>
>>Dave
>
>
no problemo. After fiddling with dovetails, making box joints is a walk
in the park! :)
Dave