I apologize if this has been covered before
I have seen several web sites pictures showing the outfeed table
attached to cabinet style saws, but I am trying to come up with ideas
to mount 3/4 MDF outfeed table to a contractor style (Craftsman) saw.
Does any one have any pictures they could post to a.b.p.w. please.
any help would be appreciated.
john
"John" <[email protected]> wrote in message
> I have seen several web sites pictures showing the outfeed table
> attached to cabinet style saws, but I am trying to come up with ideas
> to mount 3/4 MDF outfeed table to a contractor style (Craftsman) saw.
> Does any one have any pictures they could post to a.b.p.w. please.
> any help would be appreciated.
>
> john
>
In my case, the outfeed has two legs on the outside. The other end is
supported by the rail for the fence. It rests on the rail and I put a
spring clamp on either side to keep it from shifting. If you can support it
that way, just build it up so the table is equal or 1/8" below the saw
table. I guess it could be 1/6" below and work. Maybe even 3/32" and still
work. Maybe even 5/64". Nah, that would never work.
I'm at work so I don't have a picture to show you.
Ed
"John" <[email protected]> wrote in message
news:[email protected]...
> I apologize if this has been covered before
>
> I have seen several web sites pictures showing the outfeed table
> attached to cabinet style saws, but I am trying to come up with ideas
> to mount 3/4 MDF outfeed table to a contractor style (Craftsman) saw.
> Does any one have any pictures they could post to a.b.p.w. please.
> any help would be appreciated.
>
> john
>
Just posted a couple of my setup. May net be perfect for you, but at least
will give you an idea.
Ed