In the quest for a low profile undermount slide, I came across both an
online distributor and manufacturer of which I wasn't previously aware...
I reckon the folks who are still in the actual business line instead of
just hobbying or diy'ing may know of them, but...
<http://www.drawerslides.com/p/600046>
The particular link is to a center mount ball bearing glide w/ a 50#
rating instead of the 35# of the KV and Accuride varieties. Thought
that might interest some or be worth a knowing about for future
"just'n'case" something shows up.
Just a little too thick for the clearance of my existing drawers so I
went w/ the KV for the time being, but I ordered a pair of these for a
look-see as well.
--
On Fri, 11 Mar 2011 14:04:03 -0600, dpb <[email protected]> wrote:
>In the quest for a low profile undermount slide, I came across both an
>online distributor and manufacturer of which I wasn't previously aware...
>
>I reckon the folks who are still in the actual business line instead of
>just hobbying or diy'ing may know of them, but...
>
><http://www.drawerslides.com/p/600046>
>
>The particular link is to a center mount ball bearing glide w/ a 50#
>rating instead of the 35# of the KV and Accuride varieties. Thought
>that might interest some or be worth a knowing about for future
>"just'n'case" something shows up.
>
>Just a little too thick for the clearance of my existing drawers so I
>went w/ the KV for the time being, but I ordered a pair of these for a
>look-see as well.
If you need a heavier load rating rather than a center mount look at
the Accuride 3132 undermount series:
http://www.accuride.com/Resources/PDF/3132%20Eclipse%20SS.pdf
--
Jack Novak
Buffalo, NY - USA
On 3/11/2011 4:17 PM, Nova wrote:
> On Fri, 11 Mar 2011 14:04:03 -0600, dpb<[email protected]> wrote:
>
>> In the quest for a low profile undermount slide, I came across both an
>> online distributor and manufacturer of which I wasn't previously aware...
>>
>> I reckon the folks who are still in the actual business line instead of
>> just hobbying or diy'ing may know of them, but...
>>
>> <http://www.drawerslides.com/p/600046>
>>
>> The particular link is to a center mount ball bearing glide w/ a 50#
>> rating instead of the 35# of the KV and Accuride varieties. Thought
>> that might interest some or be worth a knowing about for future
>> "just'n'case" something shows up.
>>
>> Just a little too thick for the clearance of my existing drawers so I
>> went w/ the KV for the time being, but I ordered a pair of these for a
>> look-see as well.
>
>
> If you need a heavier load rating rather than a center mount look at
> the Accuride 3132 undermount series:
>
> http://www.accuride.com/Resources/PDF/3132%20Eclipse%20SS.pdf
You apparently missed out on the previous thread.... :)
I'm restricting myself at this point in time to something that will work
w/o doing more than new drawer fronts, not boxes so don't have the side
height clearance nor is the box material quite 1/2", it's 7/16" oak to
make maximum use of the openings possible since the kitchen space is
tiny...thanks, anyway.
I order enough that if the one or two heavier drawers seem a little
flimsy I'll mount two instead of just one in the center.
I just posted the above as it was both a source and a manufacturer I
wasn't familiar with and thought others might find some use in knowing
of either and/or both...
--