Dean, this is a good review, but I would have liked to hear specifically how
it did with small bits - 1/8" and less. I have an earlier model, and it's
been difficult to keep from ending up with a negative relief angle on the
little bits. There was a rumor here on the ng quite a while ago that DD had
redesigned the chuck, but I haven't heard anything since about the issue.
Your comments?
Thanks,
Tom Dacon
"HappyGilmore" <[email protected]> wrote in message
news:[email protected]...
> Hi all,
>
> have just finished a review of the Drill Doctor 750X Drill Bit Sharpener.
> You can read the review at www.onlinetoolreviews.com
>
> Hope it helps!
>
>
> --
> Regards,
>
> Dean Bielanowski
> Editor, OnlineToolReviews.com
> http://www.onlinetoolreviews.com
> Over 170+ woodworking product reviews online!
>
>
>
>
>