On 5/21/2012 8:11 PM, Leon wrote:
> On 5/21/2012 2:52 PM, Heath Roberts wrote:
>> I'm not actually looking for the jig, I'm looking for a table saw
>> alignment 'tool' that they also made...
>>
>> newyankee.com used to have a kinda discussion forum, and I think the
>> manufacturer was listed there, but I don't see it anymore.
>>
>> Thanks,
>> Heath
>
> Might want to look here also.
>
> http://www.in-lineindustries.com/saw_pals.html
M.E.G. See: http://www.megproducts.com/pro-bore32.html
"Pat Barber" wrote in message news:[email protected]...
http://www.megproducts.com/tablealignment.html
On 5/21/2012 12:52 PM, Heath Roberts wrote:
> I'm not actually looking for the jig, I'm looking for a table saw
> alignment 'tool' that they also made...
>
> newyankee.com used to have a kinda discussion forum, and I think the
> manufacturer was listed there, but I don't see it anymore.
==========================================================================================================
$90 and a few hours or three minutes and a mallet. I know which one I'd use.
On 5/21/2012 2:52 PM, Heath Roberts wrote:
> I'm not actually looking for the jig, I'm looking for a table saw alignment 'tool' that they also made...
>
> newyankee.com used to have a kinda discussion forum, and I think the manufacturer was listed there, but I don't see it anymore.
>
> Thanks,
> Heath
Might want to look here also.
http://www.in-lineindustries.com/saw_pals.html
http://www.megproducts.com/tablealignment.html
On 5/21/2012 12:52 PM, Heath Roberts wrote:
> I'm not actually looking for the jig, I'm looking for a table saw alignment 'tool' that they also made...
>
> newyankee.com used to have a kinda discussion forum, and I think the manufacturer was listed there, but I don't see it anymore.
>
> Thanks,
> Heath