"Jay Pique" wrote in message
> For those that use a stopper-block on your x-cut sled for repeat cuts,
> do you ever have problems with the cut piece binding between the blade
> and the block as you pull the sled back from the blade? Chipping?
> Just curious.
Best not to do that at all ... but ...
... if you must, but only if the parts are small enough, take a page from
David Marks and, with your hand resting on the fence, use the eraser end of
a long pencil to hold the "cut piece" firmly down when pulling the sled
back.
The pencil eraser trick also works to move small cutoff's out of the way,
either before you pull the sled back, or after, so that your hands stay
comfortably away from the blade.
--
www.e-woodshop.net
Last update: 5/6/06
"Jay Pique" <[email protected]> writes:
> For those that use a stopper-block on your x-cut sled for repeat cuts,
> do you ever have problems with the cut piece binding between the blade
> and the block as you pull the sled back from the blade? Chipping?
I never oull the pice back after the cut, I always take it away behind
the blade, except for stopped cuts, where I usually encounter no
problems.
But the my saw has a sliding table and no cross cut sled.
--
Dr. Juergen Hannappel http://lisa2.physik.uni-bonn.de/~hannappe
mailto:[email protected] Phone: +49 228 73 2447 FAX ... 7869
Physikalisches Institut der Uni Bonn Nussallee 12, D-53115 Bonn, Germany
CERN: Phone: +412276 76461 Fax: ..77930 Bat. 892-R-A13 CH-1211 Geneve 23