Hi,
I'm attaching my cabinets to the wall. Some time ago I was adviced to use a
drill size/shank hole/pilot hole table and it was very useful advice. It
saved me a lot of headache when deciding which drill to use to match the
desired screw. Now I face a similar problem when opening holes on the wall
for putting plastic anchors, and which screw to use to match the anchor's
hole. I think it could be a similar table that relates drill size/anchor
size/screw size. Where can find such a table?
Thanks in advance
--
Faustino Dina
--------------------------------------------------------
If my email address starts with two 'f'
drop the first 'f' when mailing me.
Faustino Dina wrote:
> Hi,
>
> I'm attaching my cabinets to the wall. Some time ago I was adviced to use a
> drill size/shank hole/pilot hole table and it was very useful advice. It
> saved me a lot of headache when deciding which drill to use to match the
> desired screw. Now I face a similar problem when opening holes on the wall
> for putting plastic anchors, and which screw to use to match the anchor's
> hole. I think it could be a similar table that relates drill size/anchor
> size/screw size. Where can find such a table?
Check page 55 of the following URL:
http://www.dynausa.com/documents/dyna/catalog/sectione.pdf
By the way, the above page is only "Section E". The "Main Index" can be found
at:
http://www.dynausa.com/documents/dyna/catalog/
It contains all kinds of useful reference material.
--
Jack Novak
Buffalo, NY - USA
(Remove "SPAM" from email address to reply)