I just left mine the way it is and clamp it to my workmate when I need it,
and store it out of the way when I'm not using it
Dan
"BF" <[email protected]> wrote in message
news:[email protected]...
> Hi,
>
> I could use some suggestions for mounting a new Rockler router table
top
> to a set of homemade wooden legs. I am leaning toward installing threaded
> inserts into the bottom and making it removable. Is 4 inserts enough to
> secure the top? Does anybody have any better way of doing this?
> Thanks,
BF
>
>
>
Assuming its particle board you really shouldn't need to worry about
movement so you should be able to to a direct connection of any type.
I would also assume you would build a stand that has an apron
connecting 4 legs and a shelf , tressel or braces to make it sturdy.
You don't want it swaying as you run parts through that cutter.
You could do pocket screws up from the apron. You could use table
irons (or buttons they are sometimes called) check Rockler or
Woodcraft or McFeely's. I wouldn't go with the wooden table
attachments like Norm uses. They are fine for fine furniture but not
that positive of an attachemnt for a working table. Finally, if you
like brute force, just counter sink some holes in the top and screw it
down to the apron. The top won't move (seasonaly) being particle board
and the aprons won't move enough in length to ever worry about.
BW
"BF" <[email protected]> wrote in message news:<[email protected]>...
> Hi,
>
> I could use some suggestions for mounting a new Rockler router table top
> to a set of homemade wooden legs. I am leaning toward installing threaded
> inserts into the bottom and making it removable. Is 4 inserts enough to
> secure the top? Does anybody have any better way of doing this?
> Thanks, BF
If you're talking about T-nuts, they may not work if the legs will be
subject to different seasonal movement than the top.
One thing you could consider is the sorta L-shaped wood "clips" Norm uses in
the NYW for attaching table tops. He routs or dadoes grooves on the inside
of the table aprons and screws the clips to the top. This would provide
some room for movement. I suppose in a pinch the slots could be made with a
biscuit joiner in two passes at different heights.
"BF" <[email protected]> wrote in message
news:[email protected]...
> Hi,
>
> I could use some suggestions for mounting a new Rockler router table
top
> to a set of homemade wooden legs. I am leaning toward installing threaded
> inserts into the bottom and making it removable. Is 4 inserts enough to
> secure the top? Does anybody have any better way of doing this?
> Thanks,
BF
>
>
>