All,
I'm trying to cut overlapping arches using a router with a 1/2" two-spiral,
upward-spiral bit and a template in a piece of 1x4 red oak. I'm cutting
counter-clockwise, but I keep getting tear-out as the bit exits the wood.
I'm only cutting a depth of 1/16" at a time, which seems to do better than
1/8" at a time (tried that earlier). I've even taken to screwing down the
piece that's being cut out to prevent it from breaking off too quickly, but
that didn't seem to noticeably help.
Any suggestions?
Thanks in advance.
--
Michael White "To protect people from the effects of folly is to
fill the world with fools." -Herbert Spencer
Are you using a template follower, with the router mouted in a table,
or are you hand routing from above? If you are hand routing from
above, go clockwise on exterior cuts, and counter clockwise on pockets
and interior holes, this is will cause the cuting edge to rotate into
the material. Going the opposite direction will cause the cutting edge
to lift material out of the cut, thus causing tear-out. You may also
notice that the router tries to move away from the template, I usually
make serveral passes to insure that I have routed flush to the
template. Long grain woods like oak are notorious for tear out so keep
at it, and you will get their with practice.