My front face angle indicator has come loose. The indicator now
rotates 360 degrees as I raise and lower the blade. After studying
the manual, I see that there is a worm gear wear adjustment lock nut
that will fix my problem.
Does anyone know how to fix this without removing the saw table, which
will then require realigning the whole shebang?
Thanks,
Barry
If it was too hard to reach and further loosening wouldn't cause other
internal problems I'd be inclined to try duct tape or a screw on the
front... ;-) My SWMBO hates my "temporary permanent" make-do engineering.
-- Mark
"B a r r y B u r k e J r ." <[email protected]> wrote
in message news:[email protected]...
>
> My front face angle indicator has come loose. The indicator now
> rotates 360 degrees as I raise and lower the blade. After studying
> the manual, I see that there is a worm gear wear adjustment lock nut
> that will fix my problem.
>
> Does anyone know how to fix this without removing the saw table, which
> will then require realigning the whole shebang?
>
> Thanks,
> Barry