On 10/27/2012 2:34 PM, Swingman wrote:
> Moving off a far distant, furthermost back burner, and toward a back
> burner closer to the front, is a personal bar stool project:
>
> https://picasaweb.google.com/111355467778981859077/EWoodShopMissionBarStool#
Router templates for bar stool back legs:
https://picasaweb.google.com/111355467778981859077/EWoodShopMissionBarStool#5807765305303561778
Back legs, routed out with the template pattern shown, and ready for
marking mortise locations ... along with an extra for Murphy. Front legs
can be seen in the stack in the background:
https://picasaweb.google.com/111355467778981859077/EWoodShopMissionBarStool#5809252927056371682
On the subject of wooden legs, one of the boards bought for this project
had more voids throughout than cheap Chinese plywood:
https://picasaweb.google.com/111355467778981859077/EWoodShopJustStuff#5807765456152857506
You could not rip or crosscut it at any location where these voids did
not show up, face, edge or endgrain.
When I mentioned it at the hardware lumber yard on the next trip to pick
up more stock, and showed them this photo, they replaced the $66 board
unasked and with no further questions.
They mentioned casehardening, but I don't think so ... I believe it was
cut from a tree that was stressed in some manner, leaning or twisting
during its growth.
I've cut beaucoup wood and have never seen anything that had more
interior voids than Swiss cheese ...
--
www.eWoodShop.com
Last update: 4/15/2010
KarlCaillouet@ (the obvious)
http://gplus.to/eWoodShop
I've cut beaucoup wood and have never seen anything that had more interior voids than Swiss cheese ... -- www.eWoodShop.com Last update: 4/15/2010 KarlCaillouet@ (the obvious) http://gplus.to/eWoodShop
Cool stuff. I love chair setups.
I've seen and patched similar voids with epoxy. Luckily it was in a natural colored piece of WO and the T88 epoxy was a perfect color.