I'm getting ready to order a Delta 37-275X (old 37-195) 6" jointer
from Amazon. I have used Power Twist belts on all my belted tools,
(table saw, band saw, current jointer). I would like to order a belt
while at the time of the jointer order.
Any idea what size belt I need and how long? My old delta jointer
used a narrow belt about 3/8". Is this the same for the
37-275X/37-195?
Also, is this stuff easy to use on a drill press? This is the only
belted tool that does not use the Power Twist belt. I was thinking it
would be hard to adjust the speed. My Delta 12" requires shifting the
belt while spinning the pulley.
Darrell
In the February 2004 issue of Fine woodworking on page 100, there is an
inset that exactly answers your question about using linkbelt on a drill
press. John White, the shop manager for Fine Woodworking wrote the blurb. He
claims that the link belt has enough stretch in it, that you can change belt
positions by hand without loosening the motor to give it slack. He claims
"a speed change only takes seconds".
I haven't done it yet, but will probably spring for it in the next couple of
months.
Bob
"Darrell" <[email protected]> wrote in message
news:[email protected]...
> I'm getting ready to order a Delta 37-275X (old 37-195) 6" jointer
> from Amazon. I have used Power Twist belts on all my belted tools,
> (table saw, band saw, current jointer). I would like to order a belt
> while at the time of the jointer order.
>
> Any idea what size belt I need and how long? My old delta jointer
> used a narrow belt about 3/8". Is this the same for the
> 37-275X/37-195?
>
> Also, is this stuff easy to use on a drill press? This is the only
> belted tool that does not use the Power Twist belt. I was thinking it
> would be hard to adjust the speed. My Delta 12" requires shifting the
> belt while spinning the pulley.
>
> Darrell