Newbie here. I'm just about to assemble a small bookcase I made out of 3/4
birch ply. Dimensions are roughly 32"x25"x11" and the design is very
simple. Rabbets to connect the sides to the tops and rabbets in the rear of
all pieces to accept a plywood backing. This will be a glue only affair,
and the assembly has me a little scared. Should I shoot for gluing the
carcass up first and then dropping the back in later or should I do the
whole thing at once?
Thanks for any tips...
In article <[email protected]>, [email protected] says...
> Newbie here. I'm just about to assemble a small bookcase I made out of 3/4
> birch ply. Dimensions are roughly 32"x25"x11" and the design is very
> simple. Rabbets to connect the sides to the tops and rabbets in the rear of
> all pieces to accept a plywood backing. This will be a glue only affair,
> and the assembly has me a little scared. Should I shoot for gluing the
> carcass up first and then dropping the back in later or should I do the
> whole thing at once?
>
> Thanks for any tips...
>
>
>
Six of one half a dozen of the other. If you are sure you back is square
and true, doing a complete glue up including the back saves a lot of
that measuring diagonals and such to check for square.
--
MikeG
Heirloom Woods
www.heirloom-woods.net
[email protected]
If you do the whole thing at once, the back will keep the bookcase
square so one less thing to worry about/fuss about
John
On Sat, 3 Jul 2004 17:10:33 -0700, "Travis" <[email protected]> wrote:
>Newbie here. I'm just about to assemble a small bookcase I made out of 3/4
>birch ply. Dimensions are roughly 32"x25"x11" and the design is very
>simple. Rabbets to connect the sides to the tops and rabbets in the rear of
>all pieces to accept a plywood backing. This will be a glue only affair,
>and the assembly has me a little scared. Should I shoot for gluing the
>carcass up first and then dropping the back in later or should I do the
>whole thing at once?
>
>Thanks for any tips...
>
"Travis" wrote in message
> and the assembly has me a little scared. Should I shoot for gluing the
> carcass up first and then dropping the back in later or should I do the
> whole thing at once?
>
> Thanks for any tips...
If the glue up is complicated for you, simply use the back panel to square
the rest of the assembly while the glue dries, but don't fasten it until
latter.
--
www.e-woodshop.net
Last update: 5/15/04
On Sat, 3 Jul 2004 17:10:33 -0700, "Travis" <[email protected]> wrote:
>Newbie here. I'm just about to assemble a small bookcase I made out of 3/4
>birch ply. Dimensions are roughly 32"x25"x11" and the design is very
>simple. Rabbets to connect the sides to the tops and rabbets in the rear of
>all pieces to accept a plywood backing. This will be a glue only affair,
>and the assembly has me a little scared. Should I shoot for gluing the
>carcass up first and then dropping the back in later or should I do the
>whole thing at once?
>
>Thanks for any tips...
>
unless the back is to be trapped entirely and floating in the
assembly, put the back in last.